-
Do Plastic Injection Molds Wear Out or Have a Limited Production Life?
Plastic injection molds can wear out due to friction or repeated contact between parts over thousands of cycles. Wear primarily affects...Read more -
Injection moulding surface finish design guide – DFM
Injection moulding surface finish as per SPI and VDI classification systems – Gloss, semi-gloss, matte and textured surface finish. Contents covered in this article What...Read more -
How to get good plating plastic parts
Plastic plating is an plating process that has been widely used in electronics industry, defence research, household appliances and daily necessities. The application of p...Read more -
7 ways to reduce injection molding process
There are 7 ways to reduce injection molding costs, including: Optimize the design: A well-optimized design can help to reduce the amount of material used and lower the co...Read more -
Ultrasonic Welding
Ultrasonic welding is a joining process that uses high-frequency mechanical vibrations to join two or more pieces of materials together. This process is commonly used in m...Read more -
What is the relationship between plastic injection mold and shrinkage rate?
The relationship between plastic injection mold and shrinkage rate is complex and influenced by several factors, including: 1.Material type: Different plastics have different shrinkage rates, which...Read more -
Why the plastic injected part is warpage deformation?
Warpage deformation refers to the distortion of the shape of the injection moulded product and warpage, deviating from the shape accuracy requirements of the part, it is o...Read more -
Main Process Parameters Of Injection Plastic Parts
The main process parameters of injection molded parts can be grouped into 4 factors which include: Cylinder temperature, melt temperature, injection mold temperature, injection pressure. 1.Cylinde...Read more -
TPE Overmolding
1.What is Overmolding Overmolding is a injection molding process where one material is molded into a second material. Here we mainly talk about TPE overmolding. TPE is cal...Read more -
Why the plastic part is not fully injected?
In the injection molding, the short shot injection, also called underfill , refers to the injection plastic flow end of the phenomenon of partial incompleteness or a part of a mold cavity is not f...Read more -
Wall thickness design of injection molding plastic parts
In the design of plastic parts, the wall thickness of the part is the first parameter to be considered, the wall thickness of the part determines the mechanical properties...Read more -
When to use rapid injection mould
apid injection moulding is a versatile technology that can be used to produce a wide variety of parts and products. The process is fast and efficient, and can be used to p...Read more